Terminal Description - Panasonic PAW-FC-RC1 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 32
1. Install the attached clamp-on temperature sensor at the supply pipeline from the heat pump.
Extend the cable if necessary up to 50m with J-Y(St)Y 2x2x0,8.
2. Separate the back plate from the display part with a small screwdriver. Insert him in the
grooves at the bottom of the display part and turn it slightly.
3. Connect the wires to the terminals.
Terminal
Description
L
Supply voltage 230V AC Phase
N
Supply voltage 230V AC Neutral
FAN1
Fan speed 1, digital output
FAN2
Fan speed 2, digital output
FAN3
Fan speed 3, digital output
Heating and Cooling valve actuator at 2-pipe installation, Heating valve actuator
Heat
at 4-pipe installation, digital output
Cool
Cooling valve actuator at 4-pipe installation, digital output
AI
external temperature sensor, analog input
DI
external potential-free contact, digital input
GND
Ground /reference potential for AI, DI and Modbus Com N
A
Serial communication port Com A, Modbus RTU
B
Serial communication port Com B, Modbus RTU
INSTALLATION
EN
DE
FR
ES
IT
NL
SV
NO
DK
FI
PL
CZ
HU
HR
SI
ET
LV
PT
LT

Publicidad

Tabla de contenido
loading

Tabla de contenido