Zzipp ZZSNOWJET Manual Del Usuario página 4

USE WITH WIRELESS REMOTE
1. Connect the special 5pin connector of the wireless remote receiver to the
[WIRELESS CONTROLLER] input on the back of the snow machine.
2. Fix the remote receiver with its magnetic surface to the snow machine.
3. Pull out the antenna of the wireless remote controller and press any of the A
buttons to produce snow, B button to stop snow.
DMX OPERATION
The machine provides a 3- pin XLR connector for DMX connection. The diagram below
indicates pin assignment information.
DMX Connection – Connect the machine to a DMX controller or to one of the
machines in the DMX chain. The machine uses a 3-pin XLR connector for DMX con-
nection, the connector is located on the rear of the machine.
Address Setup – Use control menu to set DMX address. The machine uses 2 control
channels. The starting address is defined as the first channel from which the machine
will respond to the controller. Always double check to make sure there are no overlap-
ping channels in order to control the machine correctly.
4