Repair Service; Disposal And Recycling - stayer SS L12 Manual De Instrucciones

Place the machine with the edge of the footplate 2 onto the wor-
kpiece and switch on. For power tools with stroke speed con-
trol, set the maximum stroke speed. Press the power tool firmly
against the workpiece and allow the saw blade 1 to slowly plun-
ge into the workpiece.
As soon as the footplate 2 fully lays on the surface of the wor-
kpiece, continue sawing alongside the desired cutting line.
For certain work, the saw blade 1 can also be inserted turned
through by 180° and the sabre saw can be guided accordingly in
a reversed manner.
Flush Cuts (see figure C)
Using elastic bimetal saw blades, items still attached to a wall
(e.g. projecting building elements such as water pipes, etc.) can
be sawn off flush at the wall.
Pay attention that the saw blade always extends be-
yond the diameter of the material being worked.
There is danger of kickback.
Position the saw blade directly against the wall and apply some
lateral pressure via the tool until the footplate faces against the
wall. Switch the power tool on and saw through the workpiece,
applying constant lateral pressure.
Coolant / Lubricant
When sawing metal, coolant/lubricant should be applied alongsi-
de cutting line because of the material heating up.
Maintenance and service instructions
Before any work on the machine itself, pull the
mains plug.
For safe and proper working, always keep the ma-
chine and ventilation slots clean.
Cleaning
Clean the saw blade holder preferably with compressed air or a
soft brush. Remove the saw blade from the power tool for this.
Ensure proper operation of the saw blade holder by applying a
suitable lubricant.
Heavy contamination of the machine can lead to malfunctions.
Therefore, do not saw materials that produce a lot of dust from
below or overhead.
Transport
The contained lithium-ion batteries are subject to the Dangerous
Goods Legislation requirements. The user can transport the ba-
tteries by road without further requirements. When being trans-
ported by third parties (e.g.: air transport or forwarding agency),
special requirements on packaging and labelling must be obser-
ved. For preparation of the item being shipped, consulting an
expert for hazardous material is required.
Dispatch batteries only when the housing is undamaged. Tape or
mask off open contacts and pack up the battery in such a man-
ner that it cannot move around in the packaging. Please also
observe possibly more detailed national regulations.
ENGLISH
19

Repair service

Our after-sales service responds to your questions conceming
maintenance and repair ofyour product as well as spare parts.
Exploded views and information on spare parts can also be
found under: info@grupostayer.com
Our customer consultants answer your questions conceming
best buy, application and adjustment of productsand accessories.

Disposal and recycling

The machine, accessories and packaging should be sorted for
environmental-friendly recycling.
Onlyfor EC countries:
Do not dispose of power tools into household waste!
According the European Guideline 2012/19/UE for
Waste Electrical and Electronic Equipment and its
implementation into national right,power tools that
are no longer usable must be collected separately
and disposed of in an environmentally correct
manner.
Subject to change wlthout notlce.
Battery packs/batteries:
Li-Ion:
Please observe the instructions in section "Transport". Do not
dispose of battery packs/batteries into household waste, fire or
water. Battery packs/batteries should be collected, recycled or
disposed of in an environmental-friendly manner.
Only for EC countries:
Defective or dead out battery packs/batteries must be recycled
according the guideline 2006/66/CE.
Regulations
Technical Data
= Voltage
=Rated power input
= Battery power
= Load speed
= Battery charging time
= Displacement of the Sierra
= Length of the blade
= Wood cutting capacity
= Capacity Metal Cutting
= Cut Aluminum Capacity
19