After Installation; Technical Information - Beacon Lighting LUCCI AIRFUSION FLUSSO Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Airfusion Flusso Installation Instructions
WOBBLE:
NOTE: ceiling fans tend to move during operation due to the fact that they are mounted on a rubber grommet. If the fan
was mounted rigidly to the ceiling it would cause excessive vibration. Movement of a few centimetres is quite acceptable
and DOES NOT suggest any problem.
TO REDUCE THE FAN WOBBLE: Please check that all screws which fix the mounting bracket .
NOISE:
When it is quiet (especially at night) you may hear occasional small noises. Slight power fluctuations and
frequency signals superimposed in the electricity for off-peak hot water control, may cause a change in fan
motor noise. This is normal. Please allow a 24-hour "breaking -in" period, most noises associated with a new
fan disappear during this time. All electric motors are audible to some extent. Please note that this is not a
product fault, and as such is not covered under warranty.
NOTE: Always turn OFF the power at the mains switch before performing any maintenance or
attempting to clean your fan.
1) Every 6 months periodic cleaning of your ceiling fan is the only maintenance required. Use a soft brush
or lint free cloth to avoid scratching the paint finish. Please turn OFF electricity power when you do so.
2) Do not soak or immerse your ceiling fan in water or other liquids. It could damage the motor or the blades
and create the possibility of an electrical shock.
3) Ensure that the fan does not come in contact with any organic solvents or cleaners.
4) To clean the fan blade, wipe with only a damp clean cloth with NO organic solvents or cleaners.
5) The motor has a permanently lubricated ball bearing so there is no need to oil.
Fan Size
FLUSSO-52-US-***
These are approximate measurements. They do not include data for any lamps or fixtures attached to the
ceiling fan.
1 year warranty covers the entire fan. Please refer to warranty card for the details.
10 | P a g e

AFTER INSTALLATION

CARE & CLEANING

TECHNICAL INFORMATION

Speed
Volts
Amps
(V)
(A)
Extra-High
120
0.46
Medium
120
0.25
High
Low
120
0.09
Watts
RPM
(W)
30.28W
196
15.08W
163
3.49W
97
WARRANTY
CFM
CFM/
N.W.
W
(lbs)
4128.10
136.33
11.2
3346.73
221.93
11.2
1955.65
560.36
11.2
V 1 . 0 ( 0 7 / 2 0 2 1 )
C.F.
1.69
1.69
1.69

Publicidad

Tabla de contenido
loading

Tabla de contenido