C-LITE C-VT-A-LVT4 LED Serie Instrucciones De Instalación

INSTALLATION INSTRUCTIONS
C-VT-A-LVT4 LED Series
CAUTIONS
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions
should always be followed including the following:
READ AND FOLLOW ALL SAFETY
INSTRUCTIONS
1. DANGER- Risk of shock- Disconnect power before
installation.
DANGER – Risque de choc – Couper l'alimentation
avant l'installation.
2. This luminaire must be installed in accordance with the
NEC or your local electrical code. If you are not familiar
with these codes and requirements, consult a qualified
electrician.
Ce produit doit être installé conformément à NEC ou
votre code électrique local. Si vous n'êtes pas familier
avec ces codes et ces exigences, veuillez contacter un
électricien qualifié.
3. Suitable for wet locations.
Convient aux emplacements mouilles.
4. Suitable for operation in ambient not exceeding 40°C.
Peut etre utilise a une temperature ambiante n'excedant
pas 40°C.
SAVE THESE INSTRUCTIONS FOR
FUTURE REFERENCE
DIRECT MOUNT INSTALLATION
1. Locate and drill holes for the (2) mounting brackets. Use the
brackets as a template for hole locations. Spacing between
brackets is 33" (83.82 cm). Required hole size for provided
expansion anchors is 15/64" (6mm). Attach brackets to mounting
surface using provided hardware. See Figure 1.
2. Attach the fixture housing to the mounting brackets by snapping
the housing into place. See Figure 2.
3. Release the (10) lens retention clips to open fixture housing. See
Figure 3.
4. Select desired wattage and CCT using the switches on the driver.
See Figure 4.
5. Reposition lens assembly on fixture housing and close the (10)
lens retention clips to secure the lens in place. Make sure all
retention clips are properly engaged and no wires or cables have
been pinched to ensure proper lens retention and sealing. See
Figure 5 on back page.
6. Route the fixture cord to a power feed location.
7. Wire the cord leads to the supply leads as indicated in Electrical
Connections section. Make sure a wet location rated canopy and
cord grip is used.
http://lighting.cree.com/warranty
Document:
LPN00865X0001A0_A
Created By:
TMT
FIGURE 1
FIGURE 2
FIGURE 3
FIGURE 4
| 866.924.3645
Date:
11-01-2021