Troubleshooting; Technical Data; Motor; Scarifier - Sabo 31-V EL Manual Del Operador

18 TROUBLESHOOTING

Fault Possible cause
No mains voltage.
Motor does not start up
within 5 seconds of the
device being switched
Connection cable
on
damaged.
Cutter blade shaft
blocked
Grass is too high
Motor stops
Blockage by foreign
bodies
Working depth to deep
Grass is too high
Unsatisfactory result
Blades are worn
Working depth not
suitable for grass and
ground conditions
Extreme vibration
Drive belt defective
Blade shaft will not
turn
Repairs to electrical machines must always be performed only by qualified electricians.
Please do not repair them yourself.
In the case of faults and defects which have not been listed here, please contact the
nearest authorized dealer. This applies in particular to appliances with electrical motors,
as when these are repaired they must always undergo an insulation protection test.
Your authorized dealer will also help you if you do not wish to perform any of the
maintenance work described here yourself.

19 TECHNICAL DATA

Motor

Motor
Connection voltage
Power
Motor speed

Scarifier

Housing
Operating width
Scarifier cutters
Adjustable-height handlebar
Grass collector capacity
Weight
Length
Remedy
Connect the mains plug C2 .
Check the fuse.
Have it checked by an

Sound power level

authorised workshop.
Have scarifying depth
checked.
Clean the cutter blade shaft

Sound pressure level

(remove the mains plug first!)
Tilt the machine during start-
up.
Have it checked by an
authorised workshop.

Vibrations

Mow the lawn first.
Have machine checked by an
authorized specialist
workshop.
Re-adjust the working depth
V2 .

20 ORIGINAL SPARE PARTS

Mow the lawn first.
Adjust the working depth
V2 .
Have the blade shaft
replaced by an authorized
specialist workshop
Re-adjust the working depth
V2 .
Have it checked by an
authorized dealer
Have it checked and replaced
if necessary by an authorized
specialist workshop.
Alternating current motor
230 V
1400 W (31-V EL)
1600 W (35-V EL)
3000 min
-1
Impact-resistant plastic (ABS)
310 mm (31-V EL)
350 mm (35-V EL)
13 pieces (31-V EL)
15 pieces (35-V EL)
2-way
50 litres
18.5 kg (31-V EL)
20 kg (35-V EL)
1330 mm
9
Width
Height
Wheels front / rear
Bearing front / rear
Guaranteed sound power level;
measured according to 2000/14/EC
Emission sound pressure level at operator's workplace;
measured according to DIN EN 13684
Measuring inaccuracy; according to ISO 4871
Vibrations on the handlebar;
measured according to DIN EN 13684
Measuring inaccuracy; according EN 12096
Scarifying blades
490 mm
990 mm
Ø 180 mm / Ø 180 mm
Sleeve bearing
L = 87 dB(A)
wa
L = 78 dB(A)
pA
1.5 dB
a = 1.5 m/s
hW
0.8 m/s
For safety reasons, scarifying blades
must always be replaced by an
authorised workshop.
This workshop has the respective spare
part numbers for the scarifying blades
available.
2
2