Make The Connections - Kohler Anthem K-28209-NA Instrucciones De Instalación

3. Make the Connections

Retention Clips
Debris Filters
Connectors
CAUTION: Risk of product damage. Do not apply excessive heat near the valve or apply flux or acids directly onto
the valve. This valve contains plastic and rubber components that will melt if heat is directly applied.
NOTE: If any outlets are not used, they must be capped or isolated using appropriate fittings.
NOTE: Do not use ammoniac flux types for soldering joints as these can cause corrosion.
Unthread the screw securing the cover to the valve. Remove the cover and set aside.
Lift and remove the retention clips.
Remove the connectors.
Remove the O-rings.
Use needlenose pliers to remove the debris filters from the hot and cold valves.
Slide the copper or brass fitting onto the inlet/outlet tube.
Solder the inlet/outlet tube to the copper or brass fittings. Allow to cool completely.
Reinstall the O-ring onto the inlet/outlet tube.
For inlet tubes only: Insert the debris filters into the end of the inlet tube.
Reinstall the connectors to the valve. Secure with the retention clips. Verify that the clips are fully inserted.
Repeat for all inlet/outlet tubes as required.
Replace the cover and secure with the screws.
1430527-2-A
O-Rings
10 Kohler Co.