Connecting The Interface Cable - Olivetti Copia 9915D Manual De Instrucciones

CONNECTING THE INTERFACE CABLE

To use the Copia 9915D as a laser printer connect it to your computer using either a parallel
interface cable or a USB interface cable. (You can use a USB interface cable only if your personal
computer has Windows 98 pre-installed)
You cannot use both the USB interface and the parallel interface at the same
time. If you connect both interfaces at the same time, the USB interface takes
precedence.
When using the parallel interface
Use an IEEE 1284 compliant parallel interface cable (2 m (6 feet) maximum length).
For specifications of the parallel interface, see page 1-25.
Check that the power switches of both the printer and the computer are in the OFF
1
position.
Plug the parallel interface cable into the printer interface connector. Fasten the two bail
2
clips at the side of the printer connector to hold the interface connector in place.
Plug the other end of the cable into the parallel interface connector on your computer.
3
(Refer to your computer manual for details.)
The printer sends and receives data bi-directionally and at high speed. Some
switch boxes and pass-through devices cannot support high-speed, bi-directional
transfer of data, and using them may cause printing errors.
1-4
All manuals and user guides at all-guides.com
Bail clip
Parallel interface connector
Interface connector
Cable