Installation/Removing The Unit - Kenwood DPX504U Guia De Inicio Rapido

the Unit
⁄
• The frame can be removed from the top
side in the same manner.
2
When the lower level is removed, remove
the upper two locations.
Removing the Unit
1
Remove the hard rubber frame by
referring to the removal procedure in
the section <Removing the Hard Rubber
Frame>.
2
Insert the two removal tools 2 deeply
into the slots on each side, as shown.
3
Lower the removal tool toward the
bottom, and pull out the unit halfway
while pressing towards the inside.
¤
• Be careful to avoid injury from the catch
pins on the removal tool.
4
Pull the unit all the way out with your
hands, being careful not to drop it.
This Product is not installed by the manufacturer
of a vehicle on the production line, nor by the
professional importer of a vehicle into an EU
Member State.
Information on Disposal of Old
Electrical and Electronic Equipment and
Batteries (applicable for EU countries
that have adopted separate waste
collection systems)
Removal tool
(Accessory )
2
The marking of products using lasers
The label is attached to the chassis/case and says
that the component uses laser beams that have
been classified as Class 1. It means that the unit
is utilizing laser beams that are of a weaker class.
There is no danger of hazardous radiation outside
the unit.
Products and batteries with the
symbol (crossed-out wheeled bin)
cannot be disposed as household
waste.
Old electrical and electronic
equipment and batteries should be
recycled at a facility capable of
handling these items and their waste
byproducts.
Contact your local authority for details
in locating a recycle facility nearest to
you.
Proper recycling and waste disposal
will help conserve resources whilst
preventing detrimental effects on our
health and the environment.
Notice: The sign "Pb" below the
symbol for batteries indicates
that this battery contains lead.
CLASS 1
LASER PRODUCT
English | 13