Operation; Start-Up And Normal Operation; Operation On Battery Power; Transfer To Battery Power - MGE Evolution 650 Manual De Instalacion Y Uso

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

E N G L I S H
3.1

Start-Up and Normal Operation

3.2

Operation on Battery Power

Transfer to battery power

Low-battery warning

End of battery backup time

All the LEDs go OFF.
The audio alarms stops.
The UPS is completely shut down.
3.3

Return of AC Input Power

Following an outage, the UPS restarts automatically when AC input power returns (unless the restart function has been
disabled via UPS personalization) and the load is again supplied.
86-81700-00 A01
All manuals and user guides at all-guides.com

Operation

Press button (10) for approximately 1 second.
The buzzer beeps once and all the LEDs go ON
simultaneously.
If AC input power is available, button (10) and LED
(13) are ON. The load is supplied by the AC-power
source. Conditions permitting, the UPS runs a
battery test, indicated by LEDs (11) and the buzzer.
If AC input power is not available, button (10) and
LEDs (13) and (14) are ON. The load is supplied by
the UPS on battery power.
The connected devices are protected by the UPS.
If LED (15) is ON, a fault has occurred (see the
"Troubleshooting" section).
The connected devices continue to be protected by
the UPS when AC input power is no longer
available. The necessary energy is provided by the
battery.
Button (10) and LEDs (13) and (14) are ON.
The audio alarm beeps every ten seconds.
The connected devices are supplied by the battery.
Button (10) and LEDs (13) and (14) are ON.
The audio alarm beeps every three seconds.
The remaining battery power is low. Shut down all
applications on the connected equipment because
automatic UPS shutdown is imminent.
Operation
3 — 1

Publicidad

Tabla de contenido
loading

Tabla de contenido