Troubleshooting Guide - Dirt Devil MSE3800 Manual Del Propietário

TROUBLESHOOTING GUIDE

WARNING: TO REDUCE RISK OF PERSONAL INJURY - UNPLUG CLEANER BEFORE SERVICING
PROBLEM POSSIBLE REASON
Cleaner won't run 1. Power cord not firmly plugged into
outlet.
2. Blown fuse or tripped breaker.
3. Needs service.
1. Dirty Water Tank is not installed
Cleaner won't pick
correctly.
up or low suction
2. Dirty Water Tank is full.
3. Incorrect cleaning tool position.
4. Incorrect cleaning solution.
Water escaping
1. Dirty Water Tank is full.
from cleaner 2. Dirty Water Tank not installed
correctly.
3. Clean Water Tank not installed
properly.
Cleaner won't
1. Spray nozzle clogged.
dispense solution
2. Clean Water Tank not installed
or is dispensing
properly.
solution at a low
3. Solution pump needs priming.
rate
4. Clean Water/Solution Tube inside
Clean Water Tank has been removed.
ANY OTHER SERVICING SHOULD BE DONE BY AN AUTHORIZED SERVICE REPRESENTATIVE
CUSTOMER SERVICE (1-800-321-1134)
In the event that further assistance is required, see your Yellow Pages for an authorized Royal
our website at www.dirtdevil.com. Costs of any transportation to and from any place of repair are to be paid by the
owner. The service parts used in this unit are easily replaced and readily available from an authorized Royal
retailer. Always identify your cleaner by the model number and manufacturing code when requesting information or
ordering replacement parts. (The model number appears on the bottom of the cleaner.)
All manuals and user guides at all-guides.com
POSSIBLE SOLUTION
1. Plug unit in firmly.
2. Check fuse or breaker in home. Replace fuse/
reset breaker.
3. Take to service center. To find nearest location,
visit our website at www.dirtdevil.com or call
1-800-321-1134.
1. Review Emptying and Cleaning the Dirty Water
Tank - Pg 8.
2. Empty Dirty Water Tank - Pg 8.
3. Reposition cleaning tool, following
Carpet/Upholstery Cleaning instructions - Pg 7.
4. Use only Dirt Devil ® cleaning solution.
1. Empty Dirty Water Tank - Pg 8.
2. Review Emptying and Cleaning the Dirty Water
Tank - Pg 8.
3. Review How to Operate - Pg 6.
1. Remove all attachments and clean thoroughly -
Pg 6.
2. Review How to Operate - Pg 6.
3. It may be necessary to prime the pump - Pg 7,
or elevate unit above nozzle by placing unit on
tabletop.
4. Replace Clean Water/Solution Tube.
® Dealer or visit
9
® Dealer or