Publicidad
Idiomas disponibles
Idiomas disponibles
INS_800-1630-0.qxd
11/18/09
READ AND FOLLOW ALL SAFETY WARNINGS AND INSTRUCTIONS IN THE OWNER'S MANUAL
Step 1:
To activate light, plug the DC adapter into
a DC receptacle. Move switch to ON.
WARNING:
Never place light face down when light is on or
is still hot from recent use. Doing so could burn/ignite
surfaces such as seats, carpeting, etc. and cause
major property damage. Always turn light off
and unplug from power source when not in use.
Step 2:
To deactivate, move switch to OFF and unplug from
power source.
Only use a Brinkmann halogen bulb that is designed for the Q-Beam Blue
Max light as a replacement. Use of any other bulb may result in poor
performance and may damage your light.
IMPORTANT: Do not touch the glass part of bulb with fingers as natural
oils affect the life and performance of bulb. Handle bulb by
metal end only.
Step 1:
Disconnect light from power source.
Step 2:
Remove the two screws from top and bottom of front housing
(see Figure 1).
Step 3:
Lay the light face (lens) down on a flat surface.
Step 4:
Holding the front housing secure, slowly lift the rear
housing off.
Step 5:
Pull reflector away from rear housing being careful not to pull
wire connections inside. Do not touch the inside of reflector.
NOTE:
The glass lens is not attached to front housing. Use care when
disassembling to avoid breaking lens.
9:30 AM
Page 3
OPERATING INSTRUCTIONS
BEFORE OPERATING LIGHT.
To Replace Bulb
Rear
Housing
Reflector
Front
Housing
FIGURE 1
Lens
2
Publicidad
