Brinkmann QBEAM GLARE-FREE BLUE MAX MARINE Manual De Instrucciones página 4

INS_800-1630-0.qxd 11/18/09
FIGURE 2
FIGURE 3
FIGURE 4
3
9:30 AM Page 4
Connector
Step 6:
Step 7:
Step 8:
Step 9:
Step 10: To install new bulb, grasp the bulb from the metal end
Step 11: Replace wire retainer by pinching ends together while pressing
Step 12: Reconnect the bulb wire to the connector as illustrated
Step 13: To reassemble, place the front housing face (lens) down on a
Step 14: Replace the two screws that were removed in Step 2. Do not
Connector
Replacement bulbs and accessories may be purchased from The Brinkmann
Corporation Consumer Sales Department by calling 800-468-5252.
Disconnect bulb wire from connector by holding the connector
firmly with fingers then pulling bulb wire straight out as shown
in Figure 2.
Pinch the ends of the wire retainer together and lift up as
illustrated (Figure 3).
Pull bulb straight out from the reflector mounting plate.
Disconnect bulb wire from connector by holding the connector
firmly with fingers then pulling bulb wire straight out.
(DO NOT TOUCH THE GLASS PART) and insert into the
reflector mounting plate. Align the slots in the bulb base with
those in the reflector mounting plate.
down. Push ends apart so they catch on the reflector
mounting plate.
in Figure 4.
flat surface. Set the reflector into housing. Insert the rear hous-
ing into the front housing of the light.
over tighten screws.