Manuales relacionados para Truper MAX-20D
Resumen de contenidos para Truper MAX-20D
- Página 1 Manual Cordless Impact Screwdriver 20 V 1/4” Bit Holder Applies for: Codes Models 101402 MAX-20D 101406 MAX-20DS MAX-20D Read this manual thoroughly CAUTION before using the tool.
-
Página 2: Tabla De Contenido
Contents CAUTION Technical Data Power Requirements To gain the best performance of the tool, prolong the duty life, Safety Warnings for Power Tools make the Warranty valid if necessary, and to avoid hazards Safety Warnings for of fatal injuries please read and Cordless Impact Screwdriver understand this Manual before using the tool. -
Página 3: Technical Data
Technical Data MAX-20D MAX-20DS Code 101402 101406 Description Cordless Impact Screwdriver (with accesories) / Cordless Impact Screwdriver Bit holder 1/4” Voltage 20 V Speed Blows per 0 - 1 800 RPM 0 - 1 400 BPM 0 - 2 100 RPM... -
Página 4: General Power Tool Safety Warnings
General power tool safety warnings WARNING! Read carefully all safety warnings and instruction listed below. Failure to comply with any of these warnings may result in electric shock, fire and / or severe damage. Save all warnings and instructions for future references. -
Página 5: Safety Warnings For Cordless Impact Screwdriver
Safety warnings for Cordless Impact Screwdriver Battery and Charger Select the Adequate Bit DANGER • Use only Truper Max chargers to charge CAUTION • Use only screwdriver bits the battery. Using a different charger may cause fire or recommended by injury hazard. -
Página 6: Parts
Parts Bit holder holder collar Battery charger Battery connection teeth Rotation and block direction button Handle Switch light Battery release button Charge indicator NOTE In model MAX-20DS, battery and charger are sold Battery separately. Battery Belt clip level indicator Start Up Battery charge 1. -
Página 7: Battery Use
Start Up Battery use The battery is shipped NOT CHARGED. It is necessary to charge the battery approximately 1 hour before being able to use it. The normal charge is 32 °F to 113 °F. When not in this level the charge automatically stops until reaching the right temperature. The normal temperature for discharge / work is 32 °F to 167 °F. -
Página 8: Speed Selection
Start Up Speed selection Your tool is equipped with a speed selector that allows you to select a speed and torque according to the application: • Press the switch until the speed selector LED light turns on • Press the speed selector button. •... -
Página 9: Troubleshooting
Troubleshooting Problem Cause Solution The hammer drill • Low battery. • Charge the battery. looses efficiency. The trigger cannot be • The direction rotation button is in the blocking • Move the direction button into the rotate or reverse pushed. position. -
Página 10: Notes
Notes ENGLISH... -
Página 11: Authorized Service Centers
In the event of any problem contacting a Authorized Service Center, please see our webpage www.truper.com to get an updated list, or call our toll-free numbers 800 690-6990 or 800 018-7873 to get information about the nearest Service Center. DE TODO PARA LA CONSTRUCCIÓN AGUASCALIENTES GRAL. -
Página 12: Warranty Policy
. Transportation costs resulting from compliance of this warranty will be covered by For questions or comments, call 800-690-6990. Made in China. Imported by Truper S.A. de C.V. Parque Industrial 1, Parque Industrial Jilotepec, Jilotepec, Edo. de Méx. C.P. 54257 Stamp of the business.