Start Up
Battery use
The battery is shipped NOT CHARGED. It is necessary to charge the battery approximately 1 hour before being able to use it.
The normal charge is 32 °F to 113 °F. When not in this level the charge automatically stops until reaching the right temperature.
The normal temperature for discharge / work is 32 °F to 167 °F. If 167 °F are exceeded, the electronic control stops the tool
energy until the temperature reaches the temperature optimum new level. When the battery is below the normal tension while
working the tool stops working. Give the tool 15 minutes rest. In warm weather or after a long period of work the battery will get
too hot to recharge. Allow the battery to cool down before trying to charge again.
Installing and Removing the Battery
To install the battery into the tool handle, align the battery unit with the rails
on the inside of the tool handle and slide it into the handle until the battery
unit is firmly inserted into the tool; check that it does not slip out by itself.
To remove the battery from the tool, press the release button (C) and pull
the battery firmly out of the tool handle.
Installing the Bit
1. Position the direction button (to the center).
2. Pull the bit holder collar (D) out of the front of the tool.
3.Insert the tip and release the collar.
4. The moment you click the accessory is locked.
Remove accesory
1. Pull the bit holder collar (D) out of the front of the tool.
2. Remove the accessory from the bit holder.
Direction of rotation
• To rotate forward release the trigger and press the direction button on the
side where marks point towards the chuck.
• To reverse the turn, press it on the other side.
• The hammer drill will get blocked if the button sits in the middle.
• The first time you turn on the hammer drill and after
CAUTION
reversing rotation you might hear a click. This in normal and does not
represent a problem.
• To prevent damaging the tool, never reverse the
CAUTION
rotation direction while the hammer drill is running.
C
D
D
Forward
Reverse
7
ENGLISH