Tabla de contenido
Publicidad
Battery
charger
NOTE
In model MAX-20DS,
battery and charger are sold
separately.
Battery charge
1. Plug in the charger in a 127 V~power outlet (The green
light on the charge initiator will turn on).
2. Insert the battery into the charger sliding it as shown in
the figure. The green light will go out and the red light
should be on indicating the charge has initiated.
• When the battery is completely charged, the green light
will be on and the red light will be off.
• Disconnect the charger from the power once the charge
is completed.
• If the red light is blinking it signals a defective battery.
Replace with a new one.
• In case the green light is blinking it signal the
temperature in the battery is lower to 32 °F or higher than
113 °F. Wait until the battery temperature is in the
adequate level to be able to charge it.
6
ENGLISH
Bit
holder
Battery
connection
teeth
Rotation and block
direction button
Battery
release
Charge
indicator
Parts
Bit holder
collar
Switch
LED
light
button
20V
Belt clip
Start Up
2
Handle
Battery
Battery
level indicator
1
Publicidad
Tabla de contenido
