How To Install; Install The Appliance - Uspa UB-6635R Instrucciones Para El Uso

9 How to install

Do not plug in until installation is finished completely.
Not doing so may damage the appliance.
Caution
If electric work is needed, contact a qualified electrician or serviceman only.
Remove the existing toilet lid and seat
1. Remove the nuts, washers and cone packings from the toilet seat mounting bolts
in the back of the toilet
2. Remove the toilet seat, lid and mounting bolts.
3. Keep them in case of installing again.

Install the appliance

Installation
How to mount the plate
Place the plate and guides over each mounting
hole. Insert the mounting bolts respecting the
sequence shown in the picture.
Mounting plate Bolt guide
Washer Upper cone
How to attach and detach the unit
14
Toilet size
Mounting bolt
Mounting nut Lower cone
Occupied sensor
Slide the unit until it clicks
into plate.
Lift the unit up and forward.
The toilet dimensions must be within those shown below.
Do not install this appliance on a toilet that does not meet
those dimensional requirements.
Wall
Bigger than Bigger than
300mm~ 240mm~
MODEL
UB-6635R
UB-6635RS
UB-6635RU
This appliance is equipped with occupied sensor.
Unit will not work unless seat is occupied.
Bigger than 40mm~
Wall
(UNIT: mm)
430 480
400 450
410 460
Occupied sensor
Seat