Unpacking The Appliance; Overview Of The Components; Attaching Accessories - BOMANN SMS 6055 CB Manual De Instrucciones

Any other use is not intended and can result in damages or
personal injuries.
The manufacturer assumes no liability for damages caused
by improper use.

Unpacking the Appliance

1. Remove the appliance from the package.
2. Remove all packaging material such as films, filler, cable
ties and cardboard.
3. Check the delivery contents for completeness.
4. Should the package contents be incomplete or damages
be found, do not take the appliance into operation. Take
it immediately back to the dealer.
NOTE:
Dust or production residues can be located on the
appliance. We recommend to clean the appliance as
described under "Cleaning".

Overview of the Components /

Scope of Delivery
1 Two-level control switch
2 Motor casing
3 Mixing rod, removable
4 Adapter for whisk / Gear unit for whisk
5 Whisk
6 Lid of the dicer
7 Multi-purpose blade
8 Transparent container (for the dicer)
9 Accessory holder
Accessories (Not Shown)
Mixing bowl

Attaching Accessories

Attaching the Mixing Rod
1. Place the motor housing (2) on the mixing rod (3)
(see illustration A).
2. Tighten the motor housing in a clockwise direction by
turning it as far as it will go. Check that it is tight.
Remove the Mixing Rod
Remove the mixing rod from the motor housing by turning it
briefly in an anticlockwise direction.
Whisk
If you would like to use the whisk (5), replace the mixing rod
by the adapter (4).
1. Lock the whisk into place by applying moderate pressure
to the drive-shaft of the adapter (see Illustration B).
2. Place the motor housing (2) on the adapter (4).
3. Tighten the motor housing in a clockwise direction by
turning it as far as it will go. Check that it is tight.
SMS6055CB_IM
Dicer
WARNING:
The multi-blade is very sharp! Danger of injury!
1. Place the blade (7) (sharp edges facing downwards) on
the metal axle in the container.
2. Place the lid (6) level on the container and tighten it
(see Illustration C).
3. Place the motor housing in position and lock it into place
by turning in a clockwise direction.
Notes for Use
• Chop up large pieces of solid food before mashing
(max. Ø 1.5 cm) and add a little liquid.
• For optimum results using the egg whisk, use high-
walled vessels that are not too large.
• The appliance is designed to process only small
quantities of food! Fill the container with the maximum
quantities specified in the table!
Adapt the capacity to the foaming behaviour of the food
to be mixed. Decrease the amount if necessary.
• Interrupt the process if the maximum speed is too slow.
Reduce the quantity of the food being mixed. First break
up any solid food.
WARNING: Risk of Injury!
The motor overtravels. Wait for the assembled acces-
sory to stop running.
• Short-time operating: The appliance is designed to be
operated for short periods of a maximum of 60 seconds.
Before using again, allow to cool for approx. 60 seconds.
• Do not process hot food. There is a risk of injury from
hot liquids. The attachments are also only suitable for a
temperature of up to 60 °C.
Two-level Control Switch (1)
Level : This provides the slowest speed and cannot be
regulated.
Level : This provides the maximum speed and cannot be
regulated.
• You can achieve pulse operation by pressing the button
at intervals and then releasing it.
• Select the accessory using the following table.
37
12.10.21