Unpacking The Appliance - PALSON Vapormatik Modo De Empleo

1.3 Maintenance and cleaning
- Only use the original accessories supplied with the appliance.
- To prevent risks, do not carry out the repairs yourself. Consult the Authorised Technical Service and entrust the repairs to
suitably qualified personnel using original Palson spares.
- Always unplug the appliance, remove the plug from the mains and leave the steam cleaner to cool down before cleaning
it or servicing it.
2 Introduction

2.1 Unpacking the appliance

Unpack the steam cleaner and all the accessories. Check that it has no components missing. If possible, keep the box and
packaging to protect the appliance during transport or returning it under guarantee. Suitably dispose of the packaging material
not required. Immediately contact your distributor if you see any damage suffered during transport when you unpack the
appliance. Under no circumstance should the appliance be used if it has been damaged in any way.
* Warning! Make sure that the packaging (plastic wrapping) does not get into the hands of children. They could be suffocated.
3 To start
3.1 Accessory assembly
Before using the Vapormatik, the steam hose with the steam gun and the accessory you require should be connected to the
appliance. The Vapormatik has an accessory compartment. Open the accessory compartment pulling the yellow lock handle
upwards and pulling the compartment's transparent lid forwards (Fig. 2 and 3).
Remove the steam accessory you require and put the lid back on the compartment. Slide the edge of the lid along the groove
on top of the steam inlet and press it down firmly from behind until it snaps into place.
3.1.1 Steam hose
First connect the steam hose to the inlet located on the front of the Vapormatik. To do so, lower the black lid's panel and firmly
push the steam hose's connector until it snaps into place (Fig. 4).
To extract the steam hose, press the two buttons to the left and right of the steam connector and remove the connector from
the inlet by pulling it out (Fig. 5).
3.1.2 Extension tubes
Assemble the extension tubes if you are going to use the steam cleaner for cleaning floors or hard to reach areas. To do so,
push the open end of a pipe into the steam gun. Push it into the steam gun until the gun button clicks into place (Fig. 6). Add
one, two or three extension tubes as necessary. Press the right button and detach the pipes pulling them downwards to remove
the extension tube. 7).
3.1.3. Floor brush
Attach the floor brush to the end of the extension tube. Make sure that the brush fits into place when you assemble it (Fig. 8).
The floor brush is ideal for cleaning washable walls and floorings. It can be used with or without the cleaning cloth. Nevertheless,
we recommend using the cloth to protect the floorings if these are sensitive surfaces such as wood or lino. Put the floor brush
in the cleaning cloth and fix the material hanging underneath the cloth's clips on the right and left. Press the yellow support's
insides, open the clips and fix the cloth into place (Fig. 9).
To remove the floor nozzle, press the button (see Fig. 7) and pull the brush down to remove it.
NOTE: The floor brush comes with a separate connector for packaging reasons.
3.1.4. Accessory adaptor
The steam cleaner has several attachable accessories for more efficient and deeper cleaning of different surfaces. First
assemble the accessory adaptor so that the fittings can be connected to the steam hose. The accessory adaptor can be directly
fitted to the steam gun and the end of one or more extension pipes.
All manuals and user guides at all-guides.com
17