Replacing The Lamp; Closing The Door - AEG RKB333E2DW Manual De Instrucciones

Problem
Water flows on the floor.
The temperature in the appli‐
ance is too low/too high.
If the advice does not lead to
the desired result, call the
nearest Authorized Service
Centre.

8.2 Replacing the lamp

The appliance is equipped with a longlife
LED interior light.
Only service is allowed to replace the
lighting device. Contact your Authorised
Service Centre.
Possible cause
Stored food was not wrap‐
ped.
The melting water outlet is
not connected to the evapo‐
rative tray above the com‐
pressor.
The temperature is not set
correctly.
The door is not closed cor‐
rectly.
The food products' tempera‐
ture is too high.
Many food products are stor‐
ed at the same time.
The door has been opened
often.
There is no cold air circula‐
tion in the appliance.

8.3 Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer
to the "Installation" chapter.
3. If necessary, replace the defective
door gaskets. Contact the Authorised
Service Centre.
ENGLISH
Solution
Wrap food in suitable pack‐
aging before storing it in the
appliance.
Attach the melting water out‐
let to the evaporative tray.
Set a higher/lower tempera‐
ture.
Refer to the "Closing the
door" section.
Let the food products tem‐
perature decrease to room
temperature before storage.
Store less food products at
the same time.
Open the door only if neces‐
sary.
Make sure that there is cold
air circulation in the appli‐
ance. Refer to the "Hints and
tips" chapter.
33