Bt Connection And Playback - auna TT-186 DAB Manual De Instrucciones

EN
28

BT CONNECTION AND PLAYBACK

1. Turn on the unit by pressing the Power On/Off (15) and press the
Function button (2) to enter to BT mode.
2. The word "Disconnected" will be flashing on the LCD display, it means
the BT in non connection / searching mode.
3. Switch on the BT feature of your BT device (such as mobile phone) and
select "TT-186 DAB" BT equipment to connecting.
4. Once the connection was finished and connected successfully, the word
"Connected" will be shown on the LCD display.
5. Adjust the volume (15) to the desired level.
6. Start to playback your BT device and enjoy the music by the main unit.
7. You can press the Play/pause button (4), Skip up/ down button (7) to
control the music playback.
8. If you want to connect to another BT enabled device after you've already
successfully paired, press and hold the Play/pause button (4) for a few
seconds until the word "Disconnected" starts flashing on the LCD display
again, OR turn off the BT on the device that was previously paired. The
word "Disconnected" starts flashing again, repeat step 3-5 above.
AUX-IN connection
Connect the unit to any auxiliary device (i.e. MP3 player, or iPod ® (not
included) by connecting the Aux-in jack (10) at the rear cabinet with one
end of 3.5mm stereo cable (not provided) and the other end connect to the
auxiliary device to perform the music.
1. Press the Function button (2) to enter to " AUX" mode.
2. Adjust Volume Knob (15) to the desire volume level. Start to playback
your device. If the distortion was too high, reduce the volume level of
your auxiliary device.