Panasonic JS-950 Serie Guia Del Usuario página 14

■ Display Block Installation
Be sure to disconnect the power cable of the main block (POS Workstation) and confirm
the power is "OFF" before the operation below.
1. How to install the display block
(1) Open the screw cover of the main block (POS Workstation).
(2) Hold the display block with both hands and insert the connector section of the display block
into the connector inlet guide of the main block slowly to connect the connector.
Note: When the connector section is connected, do not press the LCD surface of the display
block.
(Failure to observe this may result in damage to functions of the LCD or touch panel.)
(3) Tighten the 2 thumbscrews of the main block by hand to secure the display block.
* Make sure that no backlash is found when trying to move the display block.
* Be sure to use hand when tightening the thumbscrews.
(4) Close the screw cover of the main block.
Hold wire between the tips of one's first two fingers as shown in figure (3), and then tighten it.
(1)
(4)
(2)
14
(3)