Panasonic JS-950 Serie Guia Del Usuario página 20

■ ID module Block installation
Be sure to disconnect the power cable of the main block (POS Workstation) and confirm
the power is "OFF" before the operation below.
1. How to mount the ID module block
(1) Place the main block to make the display block at right angle to the mounting table.
(2) Decide which side, right or left, of the display block the ID module block is mounted on.
(The contents here explain the case of the magnetic card reader mounting on the right side.)
(3) Remove Display Block. See Display Block Installation on page 6.
(4) Remove the 2 screws on the rear side of the display block using a screwdriver.
After removal of the screws, the peripheral screws can be removed from the front side of
the display block.
(5) Slide the USB cable cover toward you while pushing both sides of the USB cable cover at
the hinge section of the display block inward to remove the cover.
(6) Prepare an ID module block to be mounted.
* The ID block unit is supplied with 2 pieces of peripheral screws, 2 pieces of screws, 1
piece of long cable cover, and 1 piece of short cable cover as accessories.
(7) Handle the cable of the ID module block (positioning and securing the cable).
・ The guide channel is provided for cable positioning and securing inside the mounting
channel of the ID module block.
・ The cable shall be run under the ID module block.
(8) Put the ID module block in the position where the peripheral screws were removed on the
display block.
(9) Cable cover has direction as shown in the fig. (9)-1. Insert salient portion of Cable cover to
concave portion of Display block as shown in the fig. (9)-2 and (9)-3. Then completion
picture is fig. (9)-4.
(10) Connect the connector of the display block with the connector of the ID module block.
Secure the cable along the guide channel on the rear side of the display block.
(11) Slide USB cable cover as shown in the fig. (11).
(12) Put the supplied 2 peripheral screws in from the front side of the ID module block and
tighten the screws using a screwdriver from the rear side to secure it.
(13) Install Display Block according to Display Block Installation P.6.
(1)
(3)
20
(4)