Parallel Operation; Set Up And Operation - Power SUA3800iED Manual

• Turn the fuel valve knob to the ON
• Turn the fuel source switch to the gasoline
position.
4. Start the engine (generator). See the "Starting the
Engine (Generator)" section for starting procedure.
Parallel Operation (2 x SUA3800iED Models)
WARNING
Fire and electrocution hazard. Never connect or
disconnect the parallel cord leads when a generator
is running. Do not parallel more than two generators.
Use only AIPOWER generators for paralleling.
NOTICE
position.
Paralleling this generator to a generator that is not
compatible can cause a low voltage output that can
damage tools and appliances powered by the
generator. Do not connect or disconnect parallel
cables while the generator is running to avoid damage.
Parallel operation gives you the ability to link this
generator to a compatible AIPOWER generator for
combined running and starting power output. Use
only the AIPOWER approved cables for parallel
operation. For single generator operation, the parallel
operation cable must be removed.
NOTE:
Only connect two identical (same model) generators
together for parallel operation.

Set up and Operation

1. Align the two inverters on a firm, flat and level
surface at a minimum 20 inch apart.
WARNING
2. Both generators to be turned off and all electrical
loads disconnected before paralleling operation.
Page 24
If not spaced apart, the exhaust heat
from one generator discolors or melt
the plastic shell on other generator.
20"