Publicidad
Idiomas disponibles
Idiomas disponibles
3.
Programming the Jobs / Tightening Programs / steps / SD Load page
A
Tightening Step (TS)
- Step: Step Nº.1 ~ Step Nº.250 could be selected.
- Step Name: 6 characters are available for the name including English, Chinese, and
Number).
- RPM: The speed (rpm) that the tool will run.
- Direction: Forward (CW) CW), Reverse (CCW).
- Target: Thread Torque.
- Thread condition: This step will be finished when it meets this thread setting.
- Torque condition: This step will be finished when it meets this torque setting.
- Delay Time: The delay time interval between current step and next step.
- HI Torque: The controlle r will make a NG alarm when the torque reading value over this
setting.
- LO Torque: The controller will make a NG alarm when the torque reading value lower than
this setting.
- HI Thread: The controller will make a NG alarm when the shaft rotation cycles over this
setting.
- LO Thread: The controller will make a NG alarm when the shaft rotation cycles lower than
this setting.
NOTE: Tightening Step (TS) settings will be saved after clicking the button
.
67
Publicidad
