DJO ARTROMOT-K1 Instrucciones De Uso página 63

. . Transport
The following adjustments need to be car
ried out to prepare the ARTROMOT® K
for transport:
. Adjust the carriage to a femur length
of cm and a tibia length of
. Activate the "transport setting"
function" in the menu also
refer to . .
. Turn off the ARTROMOT® K power
switch.
. Disconnect the power cord and the
control pendant.
. Only use the original shipping box to
transport the device. ORMED GmbH
cannot be held liable for transport
damage, if the device is not shipped in
its original shipping box.
. Set the ankle joint to the horizontal
position.
. Put the foam parts
cord in the box.
. Then lower the ARTROMOT® K into
the box.
. Fold down the block
the frame and insert the foam part
for the angle joint.
. Then adjust the carriage to a tibia
length of cm so that the ankle joint
will be fixed by the foam part
the brace .
. Put the control pendant
supplied small box.
. Fold down the fixation element
for the control pendant and store the
control pendant in the box.
cm.
and the power
that secures
. Insert
in the