Connecting The Power Source - Irritrol LIFE Plus Controller 4 Manual Del Usuario

Connecting the Power Source

1. Route 4" (10 cm) of the transformer wire cable into the controller through the
conduit (C) of Figure 1 or through the knockout (if conduit is not used).
2. Connect the transformer cable brown and blue to the terminals labeled "24 Vac".
See Figure 5.
3. Plug the transformer into the wall plug socket.
- Disconnection means: Type 1Y
- Pollution degree: 2
- Rated impulse voltage: 330V
- 230-240V, 50Hz
Figure 5
Connecting the Life Plus
Control Module
In order to complete the LIFE Plus Controller assembly connect the Control Module
onto the Back Module by simply aligning the two and pressing them together.
Note: when inserting a brand new Control Module on a powered Back Module the
display will show for few seconds: NN - - STN- - P where NN is the number of
stations available.
(*) Caution: if a Life Plus 4-Station Module is missing, the number of stations
available is based on the position of the 4-Station Module to the right.
➞ i.e. If all 4 4-Station Modules are installed except for Module in the 5-6-7-8
position, Life Plus Controller will show 16 Stations, but Station 5-6-7-8 cannot be
powered because of the missing Module.
Note: the Control Module will show "NO STATION" on the display if:
• A Control Module with sufficient Backup Power is restored to its factory settings
while removed from its Back Module.
• A Control Module is restored to its factory settings while already inserted on a
Back Module with no 4-Station Modules installed.
• A brand new Control Module is inserted on a Back Module with no 4-Station
Modules installed.
• A control Module is removed from its Back Module with no 4-Station Molules
installed.
Note: after a long period without being powered or the first time the Life Plus
Controller is Powered with its Control Module installed, for best use allow 5 to 10
minutes for back-up power to charge itself before removing the Control Panel.
LIFE Plus Controller 4-8-12-16
9