Publicidad
INSTRUCTIONS FOR USE
There are two types of adapters:
- those to be applied in the upper part
of the chassis (ADAPTERS A)
- those to be applied to the lower part
of the chassis (ADAPTERS B).
ADAPTERS A
Fastening the adapters to the upper
part of the chassis (ADAPTERS A)
1 First, close the chassis.
Then, lock the front wheels into the
fixed position (fig_a) and shorten the
handlebar to its shortest position (fig
b). Rotate the safety lever to the left
(fig_c) and pull the frame's internal
handle towards you (fig_d).
Lift the handle until the frame is
completely folded (fig_e).
2 When folded, the stroller will stand
upright. Fasten the adapter as shown
making sure it clicks into place to ensure
it is secure.
3 The Ypsi chassis can be opened once
the adapters have been fastened
(fig_a).
To release Adapters A from the
chassis
- close the chassis;
- press on the side of the adapter as
show and lift it (fig_b).
ADAPTERS B
Fastening the adapter to the lower
part of the chassis (ADAPTERS B).
WARNING: check what type of
basket you have before continuing.
If your basket has a pouch above
the brake, skip point 1 and go
directly to point 2 of this paragraph.
1 If your basket, seen from the front
as in the figure, has no side buttons
you need to remove the ties at the
front of the basket. On both sides,
unfasten the buttons that keep the
tie in place and remove it. Do not
discard the ties. Instead, store them
in a safe place.
Unfasten the basket's mushroom
button from both sides of the chassis.
2 Place the adapter on the chassis,
making it coincide with the chassis'
mushroom button, as shown.
3 Before closing the red tab on the side
of the adapter, take care to exclude
the brake wire. Close the tab until it
clicks. Once secure, proceed in the
same way on the other side of the
chassis.
To unfasten Adapters B from the
chassis, perform these operations in
reverse order.
COMBINATION
1 WARNING: Fully extend the chassis'
handlebar.
2 WARNING, IT IS FORBIDDEN TO:
- fasten ONLY the top seat to the
chassis and place the child inside it
when the lower adapter is empty.
- fasten ONLY the lower seat to the
10
Publicidad
