Descargar Imprimir esta página

Technoline WS 8011 Manual De Instrucciones página 10

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 22
HOW TO PAIR MAIN UNIT AND SENSOR
1. Press [ +/CHANNEL ] button on main unit to select a channel.
2. On sensor, slide channel switch to corresponding channel. (For additional sensors, select
a different channel). Press [ RESET ] button.
3. Press [ SENSOR ] on main unit to initiate search for 433 MHz reception.
433 MHz WIRELESS SENSOR RECEPTION
If the main unit receives wireless sensor signal successfully, the signal icon "
is displayed. If the main unit can not receive sensor signal or if signal is lost, the icon "
displayed.
DAYLIGHT SAVING TIME (DST)
The clock will automatically advance the time by one hour in the spring and back an hour in
the fall. Your clock will display "DST" during summer.
RECEPTION OF RADIO CONTROLLED SIGNAL
This clock includes a built-in receiver which picks up the signal from the DCF station.
Therefore, the clock automatically sets the time, date and weekday.
● The clock automatically carries out four periodic synchronization procedures (at 2:00 AM,
8:00 AM, 2:00 PM and 8:00 PM daily) with the RC signal to correct any deviations to the
exact time.
● Once the unit synchronizes successfully to the RC signal, the signal icon "
up. Each synchronization process will take between 6 to 16 minutes.
● To manually start the signal reception, press [ RCC ] button once or press and hold it
for 3 seconds in order to stop the reception.
● The strength of radio-controlled time signal from the transmitter tower may be
Note:
affected by geographical location or building around.
● Always place the unit away from interfering sources such as TV set, computer, etc.
● Avoid placing the unit on or next to metal plates.
● Closed areas such as airport, basement, tower block, or factory are not
recommended.
SIGNAL RECEPTION INDICATOR
The signal indicator displays signal strength in 4 levels. Wave segment flashing means time
signals are being received. The signal quality could be classified into 4 types:
RC synchronize process
Weak signal quality
Acceptable signal quality
Excellent signal quality
SETTING THE TIME
● In normal time mode, press and hold [ TIME SET ] button for 3 seconds until the 12/24 Hr
flashes.
● Press [ +/CHANNEL ] / [ -/MEM ] button to set 12/24 Hour format.
● Press [ TIME SET ] button again until Hour digit flashes and press [ +/CHANNEL ] /
[ -/MEM ] button to adjust its value.
● Repeat above operations to set the time in this sequence:
12/24Hr>Hour>Minute>Second>+/-23 Time zone
"
" is
" will show
GB 3

Publicidad

loading