Getting Started - Technoline WS 8011 Manual De Instrucciones

DISPLAY
Normal time mode
1. AM/PM (12h format)
2. Timer
3. Outdoor humidity
4. Sensor signal indicator
5. Weather forecast indicator
6. Low battery indicator for sensor
7. Indoor humidity
Alarm time mode
1. Alarm time
2. Alarm icon/Alarm on
3. Alarm mode indicator

GETTING STARTED

● Remove the battery door of the clock and sensor.
● Insert 4 new AA size batteries to the clock, and 2 to the sensor according to the "+/-"
polarity mark on the battery compartment.
● Replace the battery door.
● Once the batteries are inserted, full segment of the LCD will be shown.
● Press [RESET] button of main unit first, and press [RESET] button of transmitter.
● It will automatically receive 433 MHz signal from transmitter test.
● After 5 minutes, it will turn to RC signal reception automatically
● The RC clock will automatically start scanning for the radio controlled time signal
transmitted from Germany (DCF77).
Note: In some cases, you may not receive the signal immediately due to the atmospheric
disturbance, the best reception often occurs during nighttime.
8. Indoor temperature
9. MAX/MIN indicator
10. Outdoor temperature
11. Ice Alert on
12. RC signal strength indicator
GB 2