THERMEx METZ MEDIO III STRIP Instrucciones De Montaje página 60

60
THERMEX METZ MEDIO III STRIP
NOTE: The fasteners on Thermex ceiling-integrated hoods have a clearance of 2.5 cm.
1
Measure and cut hole for the vent in ceiling.
NOTE: If models with a movable motor are
mounted with the motor on the hood, holes
must be cut out for the motor housing.
4
x18
Screw the ceiling platform to the ceiling.
INSTALLATION IN CEILING PLATFORM
FRAME INSTALLATION
1
Measure out and cut the hole for the hood in
the dropped ceiling.
2
x18
Mark the holes from the ceiling platform on
the ceiling.
5
The hood is mounted into the ceiling platform
by following steps 2-6 in the
section CEILING INSTALLATION.
2
Truss
Dropped ceiling
Measure and install four hooks in the truss.
M 423193251229082016
3
Drill the holes out.
3
Truss
Dropped
Frame
ceiling
Hang the frame on the hooks with the
included wires.
x18