minute digits will blink. Press the BACK/NEXT buttons (15/17) to set the minutes, then press the
Program/Clock set button (19) again to confirm and finish setting the time.
Note: The LCD illumination will automatically brighten for 5 seconds when you press any button in Standby
mode.
AM/FM TUNER
1. Set the FUNCTION button (12) to the TUNE position.
2. Select the desired frequency with the BAND selector.
3. Tune in to the desired radio station by turning the Tuning control knob (18). You can also use the
BACK/NEXT buttons (15/17) to automatically search for the previous or next available radio station.
4. Adjust the volume +/- to the desired level.
5. Press the POWER (11) button to turn off the radio.
FM stereo and mono reception
When an FM signal is tuned in, press the MODE button on the remote to select FM ST; this will enable
stereo reception for the broadcast. The FM stereo indicator 'ON' will appear on the LCD display.
Hints for best reception:
-
AM: The receiver has a built-in AM antenna. If AM reception is weak, slightly turning or changing the
position of the unit will usually improve the AM reception.
-
FM: The receiver has a built-in FM antenna (29) hanging at the rear cabinet. This wire should be fully
unravelled and extended for best reception.
Before use, please make sure to:
-
Remove the stylus protector.
-
Ensure the tonearm is free to move from the tonearm rest. Lock the tonearm in place again when not in
use.
Listening to records
1. Set the FUNCTION button (12) to the PHONO position and lift the turntable Dust cover (7).
2. Place a record on the turntable, over the central spindle. Place the EP adapter over the central spindle
when playing 17cm EP records.
3. Set the Speed selector (4) to 33, 45 or 78 rpm depending on the record.
4. Lift the tonearm from the tonearm rest by using the Lift lever (36) and slowly move it over the record. The
Turntable platter (1) will start turning.
5. Place the tonearm (3) on the desired position of the record.
6. Gently lower the tonearm onto the record to start playing.
7. When the record is finished the tonearm will automatically stop. Lift the tonearm from the record and put it
back on the rest.
8. To stop manually, lift the tonearm from the record and return it to the rest.
OPERATING THE RADIO
OPERATING THE GRAMOPHONE
5