Positioning And Mounting The Uv; Connection To Your Pipework; Important - GRE UVC25 Manual De Instalación Y Funcionamiento

POSITIONING AND MOUNTING THE UV

Fitting mounting brackets (25W)
Stainless steel brackets and screws can be found in bags inside the packaging.
You will need to install these mounting brackets to the rear of the UV at each
end using a 3mm allen key. HAND TIGHTEN ONLY.

CONNECTION TO YOUR PIPEWORK

IMPORTANT: Do not overtighten fittings.
Please note that there is no correct direction of flow through the unit, either end of the unit
may be used as the inlet or outlet.
IMPORTANT: Valves positioned after the UV must never be closed when the pump is in
operation. DO NOT "dead-head" the unit.
All units are fully serviceable without removing the unit
therefore they do not need a by-pass to be installed.
INSTALLING A BY-PASS - 25W
ENGLISH
Double
Union
Ball Valve
Insert
Pipe
By-
Pass
7
3mm
Double
Union
Ball Valve
Insert
Pipe
By-
Pass
8mm