Publicidad
Idiomas disponibles
Idiomas disponibles
rest of the vehicle seat (Fig. 4) to make sure it
is securely in place.
- Check that the two connectors are fastened cor-
rectly by trying to pull the base multiple times.
- Position the Support Leg (G) and adjust it
using the adjustment button (H) (Fig. 5).
When the support leg is installed correctly,
the acoustic signal will stop and at the same
time, the indicator (I) will turn green (Fig. 6).
REMOVAL
Press the support leg adjustment button (H)
and shorten it to the end stop. Lift the ISOFIX
connector extraction lever (B) and move the
base away from the backrest to the end stop.
Release the ISOFIX connectors by pushing the
release buttons (D) (Fig. 7).
Hold down the ISOFIX connector extraction
lever (B), push the ISOFIX base into the base,
making sure to reach the end stop. Turn the
support leg and fasten the feet in the provided
slot, deactivating the acoustic signal.
WARNINGS ELECTRICAL PARTS
• To replace the battery: loosen the screw lo-
cated on the foot of the support leg (Fig. 8),
open the cover (Fig. 9), remove the drained
battery from the compartment, insert the
new battery, making sure that the correct
battery polarity is observed (positive pole
facing upwards) (Fig. 10), refit the cover and
tighten the screw fully.
• Batteries must only be replaced by an adult.
• Use a 3V, CR 2032 battery similar to the type rec-
ommended for the operation of this product.
• Always keep batteries and tools out of reach
of children.
• Always remove flat batteries from the prod-
uct to prevent any possible liquid leaks from
damaging it.
• Do not throw dead batteries into a fire or
leave them in the environment; they must be
disposed of through waste sorting.
• If the batteries are leaking liquid, replace them
immediately, making sure to clean the battery
compartment; thoroughly wash your hands if
they have come into contact with the liquid.
• Always dispose of leaking batteries immediately:
they can cause burns or other types of injuries.
• Prevent the electric part from coming into
contact with water or fluids; water will dam-
age the electronic circuit.
DISPOSING OF THE PRODUCT
When the child car seat no longer complies
with the original safety standards, stop using
it and dispose of it at an appropriate collection
point. Dispose of the child car seat always fol-
lowing environmental rules and regulations
adopted within the country of use.
CONFORMITY WITH EU DIRECTI-
VE 2006/66/EC as amended.
The crossed bin symbol on the bat-
teries or the product packaging indi-
cates that, at the end of their life, they must be
disposed of separately from domestic waste, ei-
ther by taking them to a separate waste disposal
site for batteries or by returning them to your
retailer when you buy similar rechargeable or
non-rechargeable batteries. Chemical symbols
(Hg for mercury, Cd for cadmium, Pb for lead)
printed beneath the crossed-out wheeled bin
symbol indicate the type of substance contained
in the battery. The user is responsible for taking
the batteries to special waste disposal sites at the
end of their life so they can be processed and
recycled. The correct separate waste disposal of
your old toy will help prevent potential negative
consequences for the environment and human
health and favour the recycling of the materials
of which the product is made. Illegal disposal of
the product by the user will damage the environ-
ment and human health. For further information
regarding the waste disposal services available,
contact your local waste disposal agency or the
shop where you bought the appliance.
WARRANTY
The product is guaranteed against any con-
formity defect in normal conditions of use as
stated in the instructions. Therefore, the war-
ranty does not apply in the case of damage
caused by improper use, wear or accidental
events. For the duration of warranty on con-
formity defects please refer to the specific
provisions of national laws applicable in the
country of purchase, where provided for.
11
Publicidad
