Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Always plug heaters directly into a wall outlet/receptacle. Never use with an extension cord
or relocatable power tap (outlet/power strip).
Always unplug heater when not in use.
Do not run power cord under carpe ng. Do not cover cord with throw rugs, runners or
similar coverings. Arrange cord away from traffic area where it will not be tripped over.
To disconnect heater, turn controls off then remove plug from outlet.
Do not insert or allow foreign objects to enter any ven la on or exhaust opening as this
may cause an electric shock or fire or damage the heater.
To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not use on
so surfaces like a bed, where openings may become blocked.
A heater has hot and arcing or sparking parts inside. Do not use it in areas where gasoline,
paint or flammable liquids are used or stored.
Use this heater only as described in this manual. Any other use not recommended by the
manufacturer may cause fire, electric shock or injury to persons or property.
USAGE
HEATER OPERATION: Always operate the heater in the upright posi on following all
instruc ons and recommenda ons listed in this manual HEATER LOCATION: Place the
heater in the area of the room that is coldest. HEATER CONNECTION: Plug heater directly
Into 220-240 volt A.C., 50Hz wall outlet. Be sure plug fits ghtly in outlet. A loose
connec on may cause overhea ng and damage to the plug or heater. NOTE: To prevent
overloading a circuit, do not plug the heater into a circuit that is servicing other electrical
needs.
TURNING HEATER ON:
For Flame Effect Only- Slide main power ON/OFF switch to ON posi on to have the flame
effect without any heater func ons.
For Low Heat-Slide main power ON/OFF switch to ON posi on and Slide switch "I" to ON
posi on.
For High Heat-Slide main power ON/OFF switch to ON posi on and slide both switch "I" and
switch "II" to ON posi on.
2
Publicidad
