Publicidad
Idiomas disponibles
Idiomas disponibles
SETTING THERMOSTAT: A er heater has been turned on and the room has reached the
desired temperature, slowly rotate the thermostat knob counter-clockwise un l the heater
shuts off (you should hear a faint "click") By leaving the thermostat at the se ng it will
automa cally maintain this temperature. To lower the temperature, rotate the knob further
counter-clockwise towards the LOW(-) posi on. To raise the temperature, rotate the
thermostat knob clockwise towards the HIGH(+) posi on.
TURNING OFF: Turn the Main Power On/Off power switch OFF to discon nue use. The Low
Heat Switch and High Heat Switch can remain in any posi on and will have no power. They
will con nue to have the same set func ons when the heater is turned back on. Heater
should be unplugged when not in use.
IMPORTANT SAFETY FEATURES
The heater is equipped with an automa c overheat protec on device located inside the
body of the heater. If the heater grille is obstructed, or if the heater gets too hot for any
reason, the automa c overheat protec on device will turn the heater off. To reset the
heater, simply turn power off and unplug the heater for 10 minutes un l it cools down and
you may plug the heater in and restart the heater. Be sure that the heater is on a smooth
level surface with no obstruc ons.
CARE AND MAINTENANCE
CLEANING: CAUTION-Before cleaning the heater be sure to disconnect power cord and
allow the heater to cool completely. Clean the outside surface with a clean damp cloth. Do
not use harsh chemical or abrasive cleaners. DO NOT IMMERSE THE HEATER IN WATER.
Allow heater to dry completely before use. Use a vacuum or duster to keep heat and vent
area clean and free of dust and dirt.
LEG ASSEMBLY:
Simple assembly is required if the legs of your heater arrive unassembled Using a
screwdriver, thread three screws through the holes in each leg as illustrated in Fig.1 below
and ghten them down counter-clockwise onto the underside of the heater. Please note:
extra screws are provided, you may have some le over a er assembly.
REPAIR:
DO NOT OPERATE THE HEATGER WITHOUT THE GRILLE IN PLACE. DO NOT USE THE HEATER IF
IT HAS MALFUNCTIONED OR BECOME DAMAGED IN ANY WAY. DO NOT REMOVE BACK COVER
OF HEATER; NO SERVICEABLE PARTS.
3
EN
Publicidad
