Publicidad
Idiomas disponibles
Idiomas disponibles
CAUTION
Risk of damage to the floor covering. Do
not operate the appliance on the spot.
NOTICE
Apply the detergent while in forward mo-
tion. After that, work the detergent into the
carpet in a criss-cross manner.
Finish operation
Place the slider vertically and arrest.
Place the appliance on a containment
(preserves the brushes).
Carry out maintenance jobs "after work"
(see section "Maintenance and Care").
Set the appliance switch to "0".
Disconnect the main plug from the
socket.
Wrap the mains connection cable
around the hooks on the slider.
Store the appliance in a dry room.
Transport
CAUTION
Risk of injury and damage! Observe the
weight of the appliance when you transport it.
When transporting in vehicles, secure
the appliance according to the guide-
lines from slipping and tipping over.
Storage
CAUTION
Risk of injury and damage! Note the weight
of the appliance in case of storage.
This appliance must only be stored in inte-
rior rooms.
Care and maintenance
DANGER
Risk of injury!
Pull the plug from the mains before carrying
out any tasks on the appliance.
CAUTION
Risk of damage to the appliance on ac-
count of water leakage. Remove the deter-
gent tank before doing any work on the ap-
pliance.
Maintenance schedule
After the work
CAUTION
Risk of damage. Do not wash down the ap-
pliance with water and do not use aggres-
sive detergents.
Check electrical cable and plug for
damages. Get defective parts replaced
by Customer Service.
Empty the detergent tank and rinse with
hot water (max. 50 °C).
Fill a small amount of hot water into the
detergent tank.
Reattach the detergent tank to the ap-
pliance.
Flush the nozzle by pressing the deter-
gent button.
Remove nozzle, rinse under running
water and insert in the nozzle holder on
the push handle.
Empty detergent tank.
Cleaning the sieve
Remove the brushes and rinse with
warm water.
Clean the brush tunnel.
Reinstall the brushes and exchange
their positions to preserve them.
Detach the coupling in the detergent
hose to prevent undesired water leaks
on the nozzle.
Remove the waste container and clean it.
Clean the outside of the appliance with
a damp cloth which has been soaked in
mild detergent.
Check the brushes for wear, replace if
required.
The brushes are considered worn, if the
bristles have the same length as the
yellow indicator bristles.
Weekly
Check appliance for damage, have
damages repaired by customer service.
Check spray pattern of the nozzle.
Clean or replace the nozzles as needed.
Yearly
Have the prescribed inspection carried
out by the customer service.
– 4
EN
13
Publicidad
