Restoring The Factory Settings; Performing A Functional Test; Using The Parking Aid - Dometic WAECO MagicWatch MWE910 Instrucciones De Montaje Y De Uso

MagicWatch MWE910, 900, 900F
Suppressing the display of fixed objects (such as trailer hitches)
(MWE910)
Supplementary to fig. d
➤ Insert a cable bridge (1) in the plug for the rear sensor control unit
between slots 4 and 16.
Suppressing the display of fixed objects (such as trailer hitches)
(MWE900)
➤ Set parameter 10 to 1, so that fixed objects are no longer displayed.

Restoring the factory settings

➤ Press both buttons for longer than two seconds.
✓ The display shows F5.
9

Performing a functional test

To test the parking aid, drive towards something slowly such as a wall.
NOTICE!
A
Be very careful when you operate the device for the first time, and
make sure that you familiarize yourself with the various sequences
of beeps (fig. e).
10

Using the parking aid

The rear sensors (MWE910/900) are activated automatically by engaging
the reverse gear with the ignition on or the engine running.
The front sensors (MWE910/900F) are activated automatically once the
speed of the vehicle is between 0 and 10 km/h and the ignition is switched
on.
If the speedometer signal cannot be detected, the front sensors are activated
when the ignition is switched on or when you engage the reverse gear. After
the adjustable switch-off time has elapsed they are deactivated automatical-
ly. A MWS-910 switch (accessory) can also be installed for activating the
front sensors.
EN
All manuals and user guides at all-guides.com
Performing a functional test
29