Repair Service; Disposal And Recycling; Technical Specifications - stayer MULTI DRILL 130 Manual De Instrucciones

Usually the brushes will not wear out simultaneously.
lf one brush is worn out, replace both brushes. Make
sure the brushes are installed as illus trated. The curved
surface of the brush must match the curvature of the
commutator.
3 After replacing brushes the tool should be run at
no-load; place it on a clean surface and run it freely
at full speed far 5 minutes befare loading (ar using)
the tool. This will allow the brushes to "seat" properly
and will give you more hours of life from each set of
brushes. This will also extend the total life of your tool
since the com mutator surface will "wear" longer.
Bearings
This model features a double ball bearing construction.
Under normal use they will not require lubrication.
Extension cords
If an extension cord is necessary, a cord with adequate
size conductors that is capable of carrying the current
necessary for your tool must be used. This will prevent
excessive voltage drop, loss of power or overheating.
Grounded tools must use 3-wire extension cords that
have 3-prong plugs and receptacles.
The smaller the gauge number, the heavier the cord.
Recommended sizes of extension cords 120 volt
alternating current tools.
Cord size in A.W.G
Tool´s a,pere
Cord length in feet
rating
25 50 100
3-6 18 16 16
6-8 18 16 14
8-10 18 16 14
10-12 16 16 14
12-16 14 12
MAINTENANCE AND SERVICE INSTRUCTIONS
6.
Before any work on the machine itself, pull the plug.
For safe and proper working, always keep the
machine and ventilation slots clean.
Cleaning
In extreme conditions, always use dust extraction as
far as possible. Blow out ventilation slots frequently
and install a residual current device. When working
metals, conductive dust can settle in the interior of the
power tool. The total insulation of the power tool can be
impaired.
If the machine should fail despite the care taken in
manufacturing and testing procedures, repair should be
carried out by an after-sales service centre for STAYER
power tools.
Wire sizes in mm²
Cord length in meter
150 15 30
14 0.75 0.75
12 0.75 1.0
12 0.75 1.0
12 1.0 2.5
- - - -
ENGLISH
22

Repair service

Our after-sales service responds to your questions
concerning maintenance and repair of your product as
well as spare parts.
Exploded views and information on spare parts can also
be found under: info@grupostayer.com
Our customer consultants answer your questions
concerning best buy, application and adjustment of
products and accessories.

Disposal and recycling

The machine, accessories and packaging should be
sorted for environmental-friendly recycling.
Only for EC countries:
manner.
Subject to change without notice.

TECHNICAL SPECIFICATIONS

7.
These data are valid for nominal voltages of [U] 230/240
V ~ 50/60 Hz - 110/120 V ~ 60 Hz. The values may vary
if the voltage is lower, and in specific versions for certain
countries. Pay attention to the article number on the
60 120
nameplate of your appliance, as the commercial names
of some appliances may vary.
1.5 2.5
2.5 4.0
2.5 4.0
4.0 -
- -
22
Do not dispose of power tools into
household waste! According the European
Guideline 2012/19/EC for Waste Electrical and
Electronic Equipment and its implementatio
into national right, power tools that are no
longer usable must be collected separately
and disposed of in an environmentally correct