Publicidad
Idiomas disponibles
Idiomas disponibles
2.7 User Menu Descriptions
This section provides a more detailed description of the selections found in the User Menu
Chart. Factory-set defaults are shown in bold with a checkmark (√).
NAME/CODE
S1
Selects the baud rate for data transmission through the serial port
Baud Rate
S2
Selects the number of data bits and parity of serial transmission.
Data Bits and
"8n" = 8 data bits with no parity bit and one stop bit
Parity
"7O" = 7 data bits with odd parity bit and one stop bit
"7E" = 7 data bits with even parity bit and one stop bit
"7n" = 7 data bits with no parity bit and two stop bits
S3
Selects when data will be sent out of the serial port to a printer or
Mode of Serial
computer:
Transmission
"C" = Continuous Mode; Send Data continuously
"d" = demand mode; send data when a PRINT command is issued from
the printer, computer or indicator
S4
Actuates the function that illuminates all digit segments, decimal points,
Display Check
LCD enunciators in a test sequence. Pressing the [ZERO] key to scroll
down one level begins the test sequence
S5
Allows the lb/kg to be disabled so that an operator cannot accidentally
Disable the
press the key and change the displayed units.
lb/kg Key
"0" = Disable the lb/kg key "1" = Enable the lb/kg key
S6
Selects the mode of the RS-232 serial port: Refer to Appendix B for
Serial Port
more information
Mode
"0" = Full Duplex Mode
"1" = Print Ticket Mode
S7
Allows the ID number to be disabled in the Print Ticket Mode. Valid only
ID No. Enable
when S6 is set to "1"
"0" = Disable the ID No.
S8
Actuates the function that allows entry of a new ID No. Valid only when
ID No. Entry
S6 is set to "1". Pressing the [ZERO] key to scroll down one level begins
the sequence.
S9
Actuates the function that allows entry of the desired number of line
No of Line
feeds to be printed in Print Ticket Mode. Valid only when S6 is set to "1".
Feeds
Pressing the [ZERO] key to scroll down one level begins the sequence.
S10
Enables hardware handshaking for Print Ticket Mode. Valid only when
Handshaking
S6 is set to "1".
Enable
"0" = Disable Handshaking
S11
Tells the printer to print the header information. Valid only when S6 is set
Print Header
to "1".
"0" = Do NOT Print Header
PS-IN202 (SS) Indicator
All manuals and user guides at all-guides.com
DESCRIPTION
"1" = Enable the ID No.
"1" = Enable Handshaking
"1" = Print Header
- 10 -
CODE/VALUE
1200
2400
4800
9600√
19200
8n√
7O
7E
7n
C
d√
Press [ZERO] key to
begin sequence
0
1√
0
1√
0√
1
0 - 999999
123456√
0 – 99
8√
0√
1
0√
1
Publicidad
