Troubleshooting - Scheppach HS110 Traduccion Del Manual De Instrucciones Originales

17. Troubleshooting

Fault
Blade dissolves after switching
off the engine
Engine will not start
Motor will not work, the fuse
is active
Fire marks on the cutting
surface
48 | GB
Possible causes
To slightly tightened fastening nut
Failure mains fuse
Defective extension cable
Connections on motor or switch not
in order
Motor or switch faulty
Cross section of the extension
cable is not sufficient
Overload by a blunt saw blade
Blunt saw blade
Wrong saw blade
www.scheppach.com
Action
Tighten the right hand thread nut
Check mains fuse
Replace extension cord
Repair by electrical specialist
Repair by electrical specialist
See „Electrical connection"
Change saw blade
Have saw blade sharpened (only by an
authorised sharpening specialist) or
change it
Change saw blade