Makita 9564PC Manual De Instrucciones página 5

Esmeriladora de disco
Ocultar thumbs Ver también para 9564PC:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Switch action
1
008371
CAUTION:
Before plugging in the tool, always check to see
that the switch lever actuates properly and returns
to the "OFF" position when released.
Do not pull the switch lever forcibly without pushing
in the lock-off lever.
To prevent the switch lever from accidentally pulled, a
lock-off lever is provided. To start the tool, pull the
lock-off lever toward the operator and then pull the
switch lever. Release the switch lever to stop.
Speed adjusting dial
For 9564PCV,9565PCV
008372
The rotating speed can be changed by turning the speed
adjusting dial to a given number setting from 1 to 5.
Higher speed is obtained when the dial is turned in the
direction of number 5. And lower speed is obtained when
it is turned in the direction of number 1.
Refer to the below table for the relationship between the
number settings on the dial and the approximate rotating
speed.
Number
1
2
3
4
5
011357
CAUTION:
If the tool is operated continuously at low speeds
for a long time, the motor will get overloaded and
1. Lock-off lever
2. Switch lever
2
1. Speed adjusting
1
dial
R.P.M.
2,800
4,000
6,500
9,000
10,500
heated up.
The speed adjusting dial can be turned only as far
as 5 and back to 1. Do not force it past 5 or 1, or
the speed adjusting function may no longer work.
The tools equipped with electronic function are easy to
operate because of the following features.
Electronic function
Constant speed control
Possible to get fine finish, because the rotating
speed is kept constantly even under the loaded
condition.
Additionally, when the load on the tool exceeds
admissible levels, power to the motor is reduced to
protect the motor from overheating. When the load
returns to admissible levels, the tool will operate as
normal.
Soft start feature
Soft start because of suppressed starting shock.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
unplugged before carrying out any work on the
tool.
Installing side grip (handle)
008373
CAUTION:
Always be sure that the side grip is installed
securely before operation.
Screw the side grip securely on the position of the tool
as shown in the figure.
Installing or removing wheel guard
CAUTION:
The wheel guard must be fitted on the tool so that
the closed side of the guard always points toward
the operator.
When
using
wheel/Multi-disc, flex wheel, wire wheel brush,
cut-off wheel or diamond wheel, the wheel guard
must be fitted on the tool so that the closed side of
the guard always points toward the operator.
5
a
depressed
center
grinding

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

9564pcv9565pc9565pcv9566pc

Tabla de contenido