Noble Flame RAGNA Manual De Instalacion Y Uso página 23

Gas Bottle & Regulator
The appliance includes regulator and 60cm of gas hose. This has a flow rate capacity of 1.5kg/hr and
operates a supply pressure of 50mBar. It is suitable for most domestic propane gas cylinders
available at garden centres, retailers and gas suppliers.
When install the regulator on valve, please follow installing instruction which is in regulator bag
exactly, any failing to follow instruction may lead to serious damage!
Other regulators are available depending on the gas type and cylinder size. Please ensure that a
suitable regulator with a minimum flow rate capacity of 1.3kg/hr and relevant supply pressure is used.
Please contact your local gas supplier for further advice if needed.
The gas hose should be checked regularly to ensure it is in good condition and it is recommended
that it is replaced in accordance with standard practices.
Propane or Butane
Although the heater will work with either propane or butane, there is a difference between the two
gasses. Butane cannot be used in temperatures below 5°C, whereas propane can be used all year
round. We would recommend propane.
The Gas Hose
The appliance is supplied with 27mm clip-on regulator with 8mm inlet already attached which is
suitable for propane.
If you want to use a different regulator type or gas type then you will need to remove the installed
regulator and replace to your requirement. To change the regulator ensure to attach the gas hose to
the gas inlet connector and secure with the hose clip. New hoses can be quite stiff and hard to push
onto the inlet pipe, so soften the end of the hose by running it under a hot tap for a few seconds. Try
not to get water inside the hose.
`
1 "maximum diameter or breadth: 305 mm"
2 "maximum height (regulator not included): 600 mm"