Gas Requirements; Leakage Test - Noble Flame RAGNA Manual De Instalacion Y Uso

WARNING!!!
It is extremely important that you DO NOT route the gas hose under the directly under burner. Do not
allow the hose to touch any part of the burner or heater. The hose should be located so that it is not
subjected to undue strain or placed where is could be damaged.
Heater Stand and Location
⚫ The heater is for outdoor use only. Always ensure that adequate ventilation is provided.
⚫ Always maintain proper clearance to combustible materials of at least 2 metres.
◼ Do not place near to your house.
◼ Do not place near to shed, garage or fences.
◼ Do not place under roof covering or low overhanging trees.
◼ Do not place near to power sources or under overhanging power cables.
⚫ The heater must be placed on level firm ground.
◼ The appliance is fitted 'Overturn Shut Off Device'. If the appliance is tilted or does not stand
vertically or was to fall over it will automatically shut off gas supply and appliance would shut
down.
⚫ Never operate heater in an explosive atmosphere where petroleum or other flammable liquids
and gases are stored.
⚫ Use propane or butane gas only.
⚫ Always use the correct pressure regulator and hose assembly suitable for the gas cylinder.
Contact your local gas supplier for further advice if needed.
⚫ Dented, rusted or damaged gas cylinders may be hazardous and should be checked by your gas
supplier.
⚫ Never use a cylinder with a damaged valve connection.
⚫ Never connect an unregulated gas cylinder to the heater.
Gas connections on the heater are leak tested at the factory prior to shipment. A complete leakage
test should be performed at the installation due to possible mishandling in shipment or excessive
pressure being applied to the heater.
⚫ Make a soap solution of one part liquid detergent and one part water. The soap solution can be
applied with a spray bottle, brush or rag. Soap bubbles will appear in case of a leak.
⚫ The heater must be checked with a full cylinder.
⚫ Make sure the safety control valve is in the 'OFF' position.
⚫ Turn the gas supply from the cylinder ON.
⚫ In case of a leak, turn off the gas supply. Tighten any leaking fittings, then turn the gas supply on
and recheck.
⚫ Never do leak test while smoking.
`

GAS REQUIREMENTS

LEAKAGE TEST