Replacing Batteries; Switching The Flash Unit On And Off - Metz MECABLITZ 24 AF-1 C digital Instrucciones Del Manejo

709 47 0261.A2 24AF-1CNOPS
Do not use lithium batteries! Their higher cell voltage
may damage the electronic system of the flash unit.
Remove the batteries from the mecablitz if the flash unit is not
going to be used for an extended period of time.

4.2 Replacing batteries

The batteries are exhausted if the recycling time (elapsing
from the triggering of a full-power flash to the moment the
flash ready indicator lights up again) exceeds 60 seconds.
• Turn off the mecablitz by its main switch.
• Slide the battery compartment cover in the direction of the
arrow.
• Insert the batteries lengthwise in conformity with the indicated
battery symbols and close the battery compartment cover.
90
All manuals and user guides at all-guides.com
14.12.2010 13:27 Uhr
When loading batteries ensure correct polarity, as indi-
cated by the symbols in the battery compartment.
Mixed up battery poles may destroy the flash unit!
Replace all batteries at a time and make sure that the
batteries are of the same brand and type and have the
same capacity!
Exhausted batteries must not be thrown in the dustbin!
Help protect the environment and dispose of run-down
batteries at the appropriate collecting points.

4.3 Switching the flash unit on and off

The flash unit is switched on by its main switch. In the right
"ON" position, the mecablitz is on. To turn off the flash unit
reset the main switch to its "OFF" position.
Seite 90