Operation; Control Panel Operation; Menu Map; Configuration (Dmx) - Chauvet DJ KINTA FX ILS Manual De Instrucciones

4. Operation

This product is not designed for continual use. Make sure there are regular breaks during operation to
maximize the life of the lasers. Always disconnect the Kinta FX ILS from power when not in use.

Control Panel Operation

To access the control panel functions, use the four buttons located underneath the display. Please refer to
the Product Overview to see the button locations on the control panel.
Button Function
<MENU> Selects an operation mode or backs out of the current menu option
<UP> Navigates upwards through the menu list or increases a selected numeric value
<DOWN> Navigates downwards through the menu list or decreases a selected numeric value
<ENTER> Enables the currently displayed menu or sets a selected value into the selected function

Menu Map

Refer to the Kinta FX ILS product page on
Mode Programming Levels
2-Ch
DMX
9-Ch
Preset color C--
Automatic
P--
program
Program speed S--
Sound-active
Snd
program
Custom color u--
Infrared SEt
ILS mode iLS

Configuration (DMX)

The Kinta FX ILS works with a DMX controller. Information about DMX is in the CHAUVET DMX Primer,
which is available from the Chauvet website
DMX_Primer_rev05_WO.pdf.

DMX Personality and Starting Address

When selecting a starting DMX address, always consider the number of DMX channels the selected DMX
mode uses. If the starting address is set too high, access to some of the product's channels could be
restricted.
The Kinta FX ILS uses up to 9 DMX channels in the 9-Ch mode, which defines the highest configurable
address to 504.
The Kinta FX ILS uses 2 DMX channels in the 2-Ch mode, which defines the highest configurable address
to 511.
For information about the DMX protocol, download the DMX Primer from www.chauvetdj.com.
To select the DMX personality and starting address, do the following:
1. Press <MENU> repeatedly until 2-Ch or 9-Ch shows on the display.
2. Press <ENTER>.
3. Use <UP> or <DOWN> to increase or decrease the starting address, from d 1–511.
4. Press <ENTER>.
The display will continue to blink until the fixture receives a DMX signal.
Page 11 of 117
www.chauvetdj.com
Description
d 1–511 4-channel DMX mode
d 1–504 9-channel DMX mode
C 1–15 Preset kinta effect colors (see
FAdE
P 1–7 Automatic programs (see
SnAP
S. 01–99 Automatic program speed
Snd1–7 Sound-active programs (see
r000–255
G000–255
Sets manual kinta effect colors
b000–255
U000–255
F. 00–99 Sets strobe speed, slow to fast
on
Enables/disables infrared control
oFF
iLS1–4 Sets ILS mode
http://www.chauvetlighting.com/downloads/
for the latest menu map.
Colors and
Colors and Programs)
Colors and
Kinta FX ILS User Manual Rev. 5
Operation
Programs)
Programs)