Publicidad
Idiomas disponibles
Idiomas disponibles
Only use the device in a horizontal position. Do not shake the device.
Disassemble the device and all its components and clean them before the first use.
3.3.
1. Ground the device housing, use the grounding terminal located on the
back of the griddle.
2. Before connecting the device to the power supply, always check that the
temperature control knob is set to "0".
3. Connect the power cord to a power outlet. The green power lamp will
come on.
In two pan models, each pan has a separate power cord, thermal
protection and controls.
4. Pour water into the drawer. Top up the water in the drawer while the
device is in use.
5. Use the temperature control knob to set the preferred heating
temperature. The heating indicator will light up and it will go out when
the set temperature is reached. For a crepe maker with two pans: for the
left pan, the knob and the controls are on the left and for the right pan on
the right). The thermostat will keep the temperature constant.
Note: When used for the first time, the heating elements may emit a
small amount of smoke.
6. Carefully put a portion of the previously prepared batter on the hot pan,
and spread it over the pan with a spatula (dipping the spatula in water will
facilitate spreading). Make sure that the batter does not overflow to the
sides.
7. The finished crepes should be turned over and removed only with kitchen
utensils made of heat-resistant plastic. Sharp metal utensils can damage
the surface of the pan.
8. After using the griddle, set the thermostat to "0" and disconnect the
device from the power supply.
The device is equipped with overheating protection. In the event of a
protection trip, remove the cause and reset the device by removing the
cover and pressing the Reset button located on the back of the appliance.
Device use
Publicidad
