Westward 22XP35 Instrucciones De Operación página 8

Westward Operating Instructions and Parts Manual
Disassembling and Cable Change
Please unplug the power cord before further
action.
Disassembling to Change Inner Drum
The machine was designed for easy cable change by changing the
inner drum. The cable resides in the inner drum that is inside the
outer drum. To change the cable, follow these steps:
1. Remove the four screws that hold the drum cover to the front
of outer drum.
2. Pull the drum cover with the handgrip away from the drum
back. Meanwhile, let the cable slip out through the hand grip
and the drum cover.
3. Take the inner drum out from the outer drum. To change cable
in the inner drum, follow Steps 4 to 7.
4. Pull the whole cable out of the inner drum.
5. Uncoil the new cable completely with caution. Note: The coil is
under tension and could strike.
6. Bend the cable end as shown in the figure on the right.
7. Wind the cable into the inner drum clockwise.
8. Reverse Steps 1 through 5 to assemble the drum set.
Cable Change without Disassembling
The cable can be changed by simply pulling the old cable out from
the front of machine and then pushing the new cable in. Before
pushing in, bend the pushing-in end a little to make the work easier.
Cable Cutter removal and Connection
22XP37 has a cable that allows cutter change. To change the cutter
or add an extension cable, follow these steps.
1. Disconnect the cutter or extension cable from the cable by
pushing the key tip into the hole on the cable connector. The
two parts will come loose.
2. Slide the male coupling end on the cable into the notch of the
female coupling end on the cutter from the chamfered side
until a click is heard.
If you cannot slide the male end into the notch on
the female end from one direction, then try to do it in the
other direction. This is because the bottom of the notch on
the female end is an oblique plane.
22XP35, 22XP36, 22XP37
Drain Cleaning Guns
8