Publicidad
Idiomas disponibles
Idiomas disponibles
All manuals and user guides at all-guides.com
Read this manual. Do not attempt to operate equipment
until you have read this Manual for Safety, Operation, and
Maintenance Instructions.
NOTE: This manual is a general manual. Information in this manual may or
may not pertain to your model. Please read carefully.
NOTE: Left and right describes the location of a part with the operator
facing the outlet panel.
REMOVE GENERATOR FROM CARTON
•
Open carton from top.
•
Remove all carton inserts.
•
Remove parts and manual kits and save for assembly.
•
Cut down all four corners of the box and lay panels flat.
•
Remove generator from carton.
•
Discard all packaging.
OTHER LOOSE PARTS
1.
Oil is supplied, see engine operator's manual for correct procedure to add oil
and fuel to engine.
IMPORTANT: Before any attempt to start your generator be sure to check engine
oil (See Engine Operator's manual)
2.
Parts kit containing: protective bar (1 used), extension cord wraps (2 used),
rubber bumper (1 used), screw, 5/16-18 x 1-1/4" (2 used), screw, 1/4-20 x
3/4" (1 used), 1/4-20 keps nut with washer (1 used), 5/16-18 flange nut
(2 used), self threaded flange nut (4 used).
EXTENSION CORD WRAP FORMS AND PROTECTIVE BAR
1.
The ends of the extension cord wrap
forms are not pre-threaded. To make
assembly easier use a 7/16" socket
and ratchet to thread the self-
threading nuts onto the ends of the
extension cord wrap forms about ¼".
Remove self-threading nuts and
proceed to step 2.
2.
Attach each extension cord wrap
form (1) to panel assembly with self
threading flange nuts (2), as shown.
Tighten securely.
3.
Attach protective bar (3) to frame
with 5/16-18 x 1-1/4" screws (5) and
5/16-18 flange nuts (4). Tighten
securely.
ASSEMBLY
9- ENG
1
2
5
3
4
D28733
Publicidad
