Publicidad
Idiomas disponibles
Idiomas disponibles
2610067262 GDR GDS GDX18V-1860C 07-21.qxp_GDR GDX 7/16/21 7:30 PM Page 12
expose to high heat. The batteries may
explode.
If GCY42 connectivity module is not
purchased with the tool, or if the
replacement of the module or the
battery becomes necessary, please
follow this procedure (See Fig. 7):
-
Using a flat screwdriver or a coin,
remove the cover (25) from the side
of the handle, by turning it 1/4 turn
counter-clockwise.
-
If the tool is already equipped with
the connectivity module, remove the
battery (26), but do not remove the
connectivity module (27).
-
If the connectivity module is installed
for the first time, remove the plastic
placeholder
connectivity module compartment,
and place the connectivity module
(27) in the compartment observing
correct orientation. Note: Store the
placeholder (28) in a safe place.
Reinsert the placeholder again if the
communications module is removed.
-
Next place new battery (26) on the
top of the connectivity module with
the "+" polarity facing up.
-
Place the cover (25) over the battery
and turn it ¼-turn clockwise to lock
using a flat screwdriver or a coin.
Assembly
Never dispose of the
batteries in a fire or
(28)
from
the
Fig. 7
12
25
26
27
28
Publicidad
